Assembly Instructions - Uniflame NPG2302SS Owner's Manual

4

Assembly Instructions

1
DO NOT RETURN TO PLACE OF PURCHASE.
For assistance, call 1.800.762.1142 toll-free . Please have
your Owner's Manual and model number available for
reference .
Note: The model number can be found on the back or side of the grill .
Assembly Tips:
1 . Select an area where you will assemble this product . To
protect components, choose a smooth surface that's free of
cracks or openings .
2 . Spread out all parts .
3 . Tighten all hardware connections by hand first . Then, before
completing each step, go back and fully tighten all hardware .
Be careful not to over-tighten . That could damage surfaces or
strip threads .
4 . For best results, complete each step in the order presented .
To complete assembly you will need:
• (1) Leak Detection Solution (instructions on how to make
solution are included in "Operating Instructions" section) .
• (1) 14 .1 oz or (1) 16 .4 oz LP gas tank .
Typical assembly is approximately 30 minutes .
3
Attach Handle Assembly, Heat Plate Supports and
Igniter
D
F
x4
x 4
H
x 1
I
x 4
Outdoor LP Gas Barbecue Grill
Model No. NPG2302SS
2
Attach Legs
B
x 4
E
4
Attach Burner, Heat Shield, Igniter Wire, Wind Guard and
Regulator/Control Valve
Note: The holes at the end of the burner are required for proper air intake and should
not be obstructed . Propane will not leak out from these holes .
C
x 1
G
x 4
x 4
J
x 4
G
x 1
J
x 1