Whirlpool ED27DQ Use And Care Manual page 15

Solving common ice maker problems
PROBLEM
CAUSE SOLUTIONS
Ice dispenser 9 Freezer door open
l
Close the freezer door.
won't work
l
Ice bin not properly installed
l
Make sure bin is pushed in all the way.
l
Wrong ice in bin
l
Use only crescents from ice maker. Shake
the bin occasionally to keep cubes separated
and to obtain increased storage capacity.
l
Dispenser not used for
l
Dump old ice and make a new supply.
extended periods, causing
ice cubes to melt together
Ice dispenser
stop8 worklng
l
Ice dispenser bar held in
l
Wait about 3 minutes for the dispenser motor
too long to reset.
l
Large amounts of ice should be taken from the
bin, not through the dispenser.
Off-taste or
odor in ice
l
Ice attracts airborne odors;
l
Dump old ice and make a new supply. Store
old ice excess ice in covered container.
l
Water quality
l
Water containing minerals (such as sulfur) may
require a fitter to remove.
l
Foods not properly wrapped
l
Wrap properly. See pages 20 and 21.
l
Ice bin and freezer may
l
Clean freezer and ice bin. See cleaning chart
need cleaning
on page 18.
l
Plumbing to ice maker
l
Follow Installation Instructions for proper ice
maker water supply hook up. (See back of
refrigerator cabinet.)
l
New ice maker
l
The first few loads of ice from a new ice maker
may have an off-taste. Dump ice and make a
new supply.
Removing the door trim (dispenser area)
(ED27DQ only)
To remove the trim:
1. Remove all items from the shelf.
2. Pull trim piece straight up at each end.
To replace the trim:
1. Locate each end of trim piece above the trim
pocket opening in refrigerator door liner.
2. Push the trim piece straight down until it stops.
3. Replace items on the shelf.
15