Setting The Saw Chain - Echo CS-500P Operator's Manual

Drive link
Right hand cutter
Keep this angle
20LPX : 25°
20BPX : 30°
Push fi le as shown
Hold the fi le tipped 10° upward

SETTING THE SAW CHAIN

Preset tie strap
Tie strap
Sharpen lower edge
10°
Left hand cutter
Guard link
Important points for proper maintenance of saw
chain:
• Keep the cutters sharp at all times.
• Keep the left and the right cutters properly
aligned.
- Note that blunt or irregular cutters will result in
poor cutting performance, increased vibration
of chains and premature breakage of the saw
chain.
• Drive link serves to remove sawdust from the
groove of the guide bar.
Keep the lower edge of the drive link sharp
where indicated.
SETTING SAW CHAIN
• For setting saw chain, round fi le (4.8 mm
diameter 3/16 in.) and fl at fi le are used.
• To keep correct position and correct angle, use
the fi le holder (Sure Sharp
27
Top plate
Side plate
Depth gauge
®
).
CS-500P