8. User menu
8.1. Requesting/quitting user menu
After requesting the user menu, the following basic
settings can be selected on two planes according to
your personal preference.
First plane:
•
- Speed dependent volume control (GAL)
G a l
•
- Telephone characteristics
T e l
•
L c d
- Adjusting display
•
L e d
- Adjusting flashing diode
•
M / S
- Adjusting reception optimization
•
N a v
- Adjusting navigation announcements
Second plane:
•
A u x
- aux input setting
•
- compass display setting
C m p
•
- Adjusting signal tone volume
B e V
The user menu is requested by pressing the
for more than 2 seconds.
G a l : + 4
Gal
Tel Lcd Led M/S Nav ->
In order to access the second plane of the user menu,
press the
multifunction key.
->
Press the
key again to quit the user menu.
GAL (Gal) setting
The GAL is a car radio control circuit, which auto-
matically adjusts the car radio volume to the vehicle
speed. This compensates for the driving noise pro-
duced at higher speeds.
Request the user menu. Press multifunction key
. With the right control knob
Gal
or
+ 1 5
.
G a l : + 4
Gal
Tel Lcd Led M/S Nav ->
With the GAL settings, the beginning of volume ad-
justment can be specified according to vehicle speed.
The setting is stored automatically.
Explanation:
•
- No volume increase
0
key
•
- Volume adjustment is initiated at low speed
+ 1
•
- Volume adjustment is initiated at higher
+ 1 5
speed
Telephone mute characteristics (Tel)
If the vehicle has a telephone system with hands-free
unit, the call can be heard through the car audio sys-
tem. Thus, there is no need for the usually required
additional speaker. However, the signal cables (AF -
telephone input and ground - telephone input) must be
connected to the car radio (see page 46).
, select either
0
For selection, request user menu. Press multifunction
key
to select
Tel
T E L : m u t e
Gal
Tel
Lcd Led M/S Nav ->
•
- Telephone mute setting
m u t e
•
a u d i o s i g n a l
Display setting (Lcd)
The display setting allows you to select from three
different display versions.
• Negative Display Setting (
• Positive Display Setting (
• Automatic Display Setting (
display setting will be positive or negative depend-
ing upon the vehicle illumination.
a u d i o s i g n a l
or
m u t e
.
- Route call through radio
)
n e g a t i v
)
p o s i t i v
) – the
a u t o m a t i c
41
8. User menu