Table of Contents
Advertisement
2.3.2. Inserting the batteries in the remote control
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
1. Press and then slide the cover to open it.
2. Align the batteries according to the (+) and (–) indications inside the
battery compartment.
3. Replace the cover.
Caution:
The incorrect use of batteries can result in leaks or bursting. Be sure to follow these instructions:
•
Place "AAA" batteries matching the (+) and (–) signs on each battery to the (+) and (–) signs of the battery compartment.
•
Do not mix battery types.
•
Do not combine new batteries with used ones. It causes shorter life or leakage of batteries.
•
Remove the dead batteries immediately to prevent them from liquid leaking in the battery compartment. Don't touch exposed battery acid, as it can
damage your skin.
NOTE:
If you do not intend to use the remote control for a long period, remove the batteries.
2.3.3. Handling the remote control
•
Do not subject to strong shock.
•
Do not allow water or other liquid to splash the remote control. If the remote control gets wet, wipe it dry immediately.
•
Avoid exposure to heat and steam.
•
Other than to install the batteries, do not open the remote control.
2.3.4. Operating range of the remote control
Point the front of the remote control toward this display's remote control sensor when
pressing a button.
Use the remote control within a distance of less than 5m/16ft from this display's sensor,
and a horizontal and vertical angle of less than 30 degrees.
NOTE: The remote control may not function properly when the remote control sensor
on this display is under direct sunlight or strong illumination, or when there is an
obstacle in the path of signal transmission.
2.4. RS232 Control
See www.planar.com for Simplicity RS-232 manual.
2.5. LAN control
The Simplicity Series supports extending access to the RS232 commands over a
network connection. Below are the steps to follow for controlling the display over LAN through the RJ45 connector:
1. Connect display & PC to hub or connect display to PC with LAN cable directly.
2. SET display IP address
Step 1: In Network Settings menu, select "Network configuration"->"Static IP"
Step 2: Then go to "Static IP configuration" and enter the pertinent information.
Step 3: "View network settings" to check IP address
3. Commands are sent via TCP connection to port 5000. The commands are the same as for the RS232 port (see Simplicity RS-232 manual on www.
planar.com).
7
Simplicity Series
30
30
Advertisement
Table of Contents
Troubleshooting
