From Installation To Operation - Mitsubishi MR-WX743Y Operating Instructions Manual

From Installation to Operation

1
Installation
Space of 10 cm
or more
Space of 2 cm
or more
Install the refrigerator in the
following kind of location.
A place with good ventilation and not
exposed to direct sunlight or hot air
To keep good cooling performance and
reduce power costs.
A place with low humidity
To prevent it from rusting.
A strong and level place
To prevent vibration, noise, and ajar or
tilting doors.
To prevent deformation or discoloration of
the fl oor materials due to the weight or heat.
(If the refrigerator supports may sink
into the fl oor, lay a strong plate or
board underneath)
A place away from other devices
To prevent noise or video interference
with devices such as televisions.
There should be space of 2 cm or more
on the left and right of the refrigerator,
and 10 cm or more from the ceiling.
To allow heat to dissipate from the top
and the sides of the refrigerator.
Use in hot spring and geothermal areas
Corrosion control treatment may be required
for the refrigerant circuit (pipe) due to
generation of corrosive gases.
Contact the retail store where you purchased
the refrigerator.
Do not install the refrigerator
outdoors or in places exposed
to water or excessive humidity.
Water may cause insulation failure,
Water
resulting in an electric shock or fi re.
prohibited
Leave space around the
refrigerator.
If refrigerant leaks, it may
accumulate and catch fi re or
Follow the
instructions
explode.
6
2
Connect the Power Supply
* Connect power supply soon after installing the
refrigerator
Dedicated
outlet that meets
the specifi ed rating.
Use a dedicated outlet
Use a dedicated outlet for the power supply that meets the rating
specifi ed on the rating label. (The rating label is located on the
refrigerator compartment.)
Warning
Using outlets that do not meet the specifi ed rating or
plugging in too many leads into a single socket can cause
heat buildup or fi re.
The refrigerator will not be damaged even if the power is
supplied soon after installation.
It takes a while for the refrigerator to cool, therefore supply
power as soon as possible.
Electrical Connections
Make sure this unit is properly grounded.
The refrigerator should always be plugged into its
dedicated electrical outlet.
This will provide the best performance and prevent
electrical circuits from being overloaded and causing a
fi re.
Make sure that the electrical outlet provides the proper
voltage.
Extension cords are not recommended.
If your refrigerator is installed in the high humidity
location, not only ground connection but also installation
of the earth leakage breaker is recommended.
If the power cord is damaged, purchase a new cord from
MITSUBISHI ELECTRIC SERVICE CENTRE. Make
sure that the power cord is designed for this model, in
order to avoid a hazard.
If the power cord is damaged, call our MITSUBISHI
ELECTRIC SERVICE CENTRE or its service agent for
the replacement, in order to avoid a hazard.
Turn on the power of the
refrigerator as soon as
possible.