Table of Contents
Advertisement
Switch action
CAUTION
:
Before inserting the battery cartridge into the tool, always check to see that the switch
lever actuates properly and returns to the "OFF" position when released.
Operation
Switch on the tool and wait until the wheel
point attains full speed. Then apply the
wheel point to the blade gently. To sharpen
the blade, move the tool while maintain-
ing the angle of the wheel point in relation
to the blade.
CAUTION
:
Apply light pressure on the tool. Excessive pressure on the tool will only cause
a
poor
finish and actuation of the overload protector.
Overload protector
The overload protector automatically cuts out to break the circuit whenever heavy work
i s prolonged. When this occurs, release the switch lever and withdraw the tool from the
blade.
Wait
until the motor cools down and then resume operation.
8
Advertisement
Table of Contents
