Solid State Drive - HP ENVY m7 Maintenance And Service Manual

5. Lift the system board (2), and then remove the system board (3) by sliding it up and to the right at
an angle.
6. Turn the system board over and remove the solid sate drive before replacing the system board.
Reverse this procedure to install the system board.

Solid State Drive

Description
256 GB mSATA solid-state drive MLC (not pictured) available on select models
256 GB mSATA solid-state drive TLC (not pictured)
Before removing the speakers, follow these steps:
Before removing the Speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
Battery on page 38),
Optical drive on page
WLAN module on page
39).
Base enclosure on page
56).
Component replacement procedures
Spare part number
766593-001
766594-001
42).
69