Advertisement
E]. REPEAT BUTTON
Press the button to continuously repeat same track. Press again to
stop repeating.
F]. RANDOM BUTTON: play all tracks
Press it to play all tracks on CD in random order. Press again to stop
random play
13. POWER BUTTON
Press it to turn on or off the unit.
14. MODE BUTTON
1)When there are disc and tape in the unit, press it repeatedly to change the
mode like the following:
CD
RADIO
2)When there is disc but no tape in the unit, press it repeatedly to change the
mode like the following:
CD
RADIO
3)When there is tape but no disc in the unit, press it repeatedly to change the
mode like the following:
TAPE
RADIO
4)When there is not tape and disc in the unit, the button will be not effective.
15. EQ BUTTON
Press it repeatedly to change the music vocal modes such as POP, CLASSIC
and ROCK. The sound quality will be changed.
16. CLOCK BUTTON
Press it to change into CLOCK display mode.
Press it hold until the time be flashed on LCD, then press VOL+ or VOL-
button to adjust HOUR or MINUTE.
17,18.SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTON
Press SEL button to change the mode in the sequence of
VOL
BAS
TRE
1). The volume level can be adjusted at any time by pressing the audio
level+ or - button as select mode has been initially defaulted at volume
mode.
2). The volume level is also obtained by stepping through the SEL button
until the word VOL is displayed and then press + or - button to
adjust the sound level.
3). Press and hold the + or - button to adjust the sound level.
TAPE
BAL
FAD
3
INSTALLATION
1. Install brackets and screws removed from your old radio
(not provided with this radio).
2. Slide radio and frame into dash opening.
3. Trim ring has precut grooves on the back of it. The size of the
trim ring can be reduced (made smaller) for different types of
installations. Hold the trim ring firmly in one hand, and using
a pair of pliers, grasp the trim ring above the score line (groove)
and bend gently back and forth a couple of times. Then the piece
should break away.
4. Install dash panel.
5. Install faceplate by fitting left edge into position then pushing
right edge closed.
8
Advertisement
