Cutting Attachment In Central / Side Position; Repositioning The Cutting Attachment - Makita DPC 6400, DPC 6401, DPC 7300, DPC 7301 Instruction And Safety Manual

Cutting attachment in
central / side position
NOTE: The Power Cut is delivered with the cutting attachment
mounted in the middle position (C). For cutting up against
obstacles, such as curbs or walls, the cutting attachment can
be mounted to one side (D). Use this position only when
actually necessary, and afterwards return the cutting attach-
ment to the middle position. In this position the Power Cut has
better balance, is easier to guide, and is not as fatiguing for the
operator.

Repositioning the cutting attachment

STOP
Loosen nuts (5).
Loosen the tightening screw (3) (counter-clockwise) until the
end of the screw (4) is visible in the gap.
Unscrew the nuts (5) and remove the cover (6).
Turn the hood lock (8) clockwise as shown in the illustration (to
the highest point of the slanted level).
NOTE: The slip lock (Fig. D, 7) can only be overcome when the
hood lock (8) is in the position shown.
Turn the hood (9) as shown in the illustration.
Turn the hood lock (8) to the starting position and lock the hood
by turning it slightly (the hood lock will catch audibly).
Disengage the V-belt (10) and remove the cutting attachment.
Press the cutting attachment (11) in the side position onto the
drive arm attachment.
Guide the V-belt (10) over the V-belt wheel (12).
1 2
5
4
10
11 12 10
C
7
6
3
D
9
8
E
F
23