Toshiba e-studio2555c Quick Start Manual page 16

Chapter 1 PREPARATIONS
Saving energy when not in use – energy saving modes –
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving Procedure to switch
modes
When a specified period of
Automatic
time
Energy Save
last use of the equipment.
mode
When the [ENERGY SAVER]
button
Sleep mode when a specified period of
time
last use of the equipment.
When the [ENERGY SAVER]
button
Super Sleep when a specified period of
mode time
the last use of the
equipment.
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*3 [ENERGY SAVER] button on the control panel.
*4 The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).
*5 The Wireless LAN Module and/or e-BRIDGE ID Gate.
*6 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO (-1000MB)] or [1000BASE
FULL], the equipment enters into the Sleep mode. For details, refer to the following guide:
& TopAccess Guide (PDF): "Chapter 8: [Administration] Tab Page" - "[Setup] Item list"
*7 Depending on the network environment of the user, the time for switching to the Super Sleep mode may take more than 10 minutes even
though it has been set to 10 minutes or less.
For changing the set period of time for entering into each mode, refer to the following guide:
For the European version
Contact your service representative to change the default settings noted above.
& MFP Management Guide (PDF): "Chapter 2: SETTING ITEMS (ADMIN)" - "Setting General Functions"
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
If an original is placed on the original glass during the energy saving mode, its size will not be detected even when the equipment
is recovered from this mode. After pressing the [START] or [POWER] button to recover from the mode, such as when "READY" is
displayed on the basic copying function menu, place it on the glass again.
14
Conditions to enter into
modes
has passed since the
*1
When a particular option
is pressed or is installed or when a
*3
particular protocol
has passed since the enabled.
*4
When a particular option
is pressed or is not installed and also
*3
when a particular protocol
has passed since is disabled.
*4 *7 *6
Status of equipment
the mode
"Saving energy - press
START button. " appears on
—
the touch panel.
The touch panel display
*5
goes off and the [ENERGY
*6 is SAVER] button lights in
green.
Only the MAIN POWER
*5
lamp (green) lights.
Conditions to recover
from the mode
When a button on the
control panel is pressed
*2
or when print data or fax
data are received.
Same as the Automatic
Energy Save mode.
When the [POWER] button
is pressed, when print or
fax data are received
through a wired LAN or
when the time set for
Scheduled Print has come.