Starting A Cold Engine - Polaris 2004 Sportsman 6x6 Owner's Manual For Maintenance And Safety

Starting a Cold Engine

Carbon monoxide exhaust gas is poisonous and can cause
severe injury or death. Never run an engine in an enclosed area.
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several
minutes before operating the vehicle.
1. Place the transmission in neutral and
lock the parking brake. Make sure the
fuel tank valve is on.
2. Sit on the vehicle and pull the choke
knob (1) out until it stops. NOTE: If
the knob doesn't stay where
positioned, increase the tension by
rotating the tension adjusting nut (2)
clockwise.
NOTE: The variable choke is fully on when the
knob is pulled completely out. The choke is off
when the knob is pushed completely in. The
choke can be adjusted gradually, depending on
how much choke is needed for starting. Be sure
the choke is off during operation, as excess fuel
washing into the engine oil will increase wear on engine components.
3. Turn the engine stop switch to RUN. NOTE: Do not press the
throttle while starting the engine.
4. Turn the ignition key past the ON position to engage the starter.
Activate the starter for a maximum of five seconds, releasing the
switch when the vehicle starts. If the engine does not start, release
the starter and wait five seconds. Then activate the starter for
another five seconds. Repeat this procedure until the engine starts.
5. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up.
6. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke completely in.
WARNING
CAUTION
OPERATION
1
2
55