Table of Contents
Advertisement
To Delay Starting an Automatic Oven Operation
If a delayed cooking operation is desired:
1. Push STOP TIME pad.
2. Turn SET knob to time of day when baking should
be completed. Stop time must be equal to or greater
than the cook time plus the current time of day.
3. Push OVEN TIME pad.
4. Set length of baking time with SET knob.
5. Push BAKE pad.
6. Turn SET knob to desired temperature.
When stop time is reached, the End-of-Cycle Tone
will sound and the oven will turn off.
NOTE: Foods that spoil easily such as milk, eggs,
fish, stuffings, poultry and pork should not be allowed
to sit out for more than one hour before or after
cooking. Room temperature promotes the growth of
harmful bacteria. Be sure that oven light is off
because heat from the bulb will speed harmful
bacteria growth.
NOTE: You can push the STOP TIME pad to find out
when the oven will turn off.
Tones
End-of-Cycle Tone (3 long
beeps—one second on, one
second off): shows that a timed
oven operation has reached STOP
TIME or that the Minute/Second
Timer has counted down.
Key Tone (single, l/10-second beep): sounds when
any pad is pushed.
How to Change a Program
When a function has been entered, you can
recall what has been programmed by pushing the
corresponding function pad. The messages in the
display show you which function is currently
being displayed. While the function is displayed,
you can change it with the SET knob. You can
change any programmed function at any time.
Attention Tone (series of short
beeps, l/4-second on, l/4-second
off, until proper response is given):
will sound if oven has only been
partially programmed. For
example, if you have selected a
cook time but no temperature, you
will heat the Attention Tone until
you select a temperature or push
the CLEAWOFF pad.
Function Error Tone (series of very rapid beeps,
l/8-second on, l/4-second of~: display will show a
code. Cancel Function Error Tone by pushing the
CLEAWOFF pad. If the Function Error Tone starts
again (after about 15 seconds), call for service.
Disconnect the range electrical supply to stop the tone.
If the function error occurred while you were
programming the Oven Control, push the
CLEAWOFF pad and try again.
Pushing the CLEAIVOFF pad will clear all functions
except the Clock and Minute/Second Timer.
Notification Tone (single, one-
second beep): indicates oven has
stabilized at selected temperature.
15
Advertisement
Table of Contents
