Battery Installation – Remote Control; Battery Notice - VTech Go!Go! Smart Wheels User Manual

BATTERY INSTALLATION – REMOTE CONTROL
1. Locate the battery cover on the back of
the remote control. Use a screwdriver to
loosen the screw.
2. Install 2 new "AAA" (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
3. Replace the battery cover and tighten
the screw to secure.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
7