Wireless Access Point (Ap) - NETGEAR R6250 User Manual

Wireless Access Point (AP)

You can set up the router to run as an access point (AP) on the same local network as
another router.
To set up the router as an AP:

1. Use an Ethernet cable to connect the Internet port of this router to a LAN port in the
other router.
2. Select Advanced > Advanced Setup > Wireless AP.
3. Select the Enable Access Point Mode check box.
The AP Mode section of the screen expands.
4. Scroll down and select the check box for the IP address setting that you want to use:
R6250 Smart WiFi Router
Advanced Settings
99
Cable this port to a LAN port
on the other router