Advertisement
Dirty Dragon Guitar Amplifier Owner's Manual
Rear Panel
2
1
1 – FUSE- This is the line fuse for the amplifier. The proper fuse should be installed as
indicated on the rear panel of the unit. The table below shows the proper fuse to
be used with the indicated line voltage.
based on the line voltage noted can result in personal injury, fire, damage to the
amplifier or other nasty things too numerous to mention here.
LINE VOLTAGE
120 VAC
230 VAC
2 - AC POWER – an IEC standard removable power cable. The unit should only be
plugged into a proper AC Line Voltage as indicated on the rear panel of the unit.
4 – POWER SELECT – Power OutPut selector Full or Half – This selector should only be
changed when the unit is in the STANDBY or OFF position
3 – SPEAKER OUT - ¼" jack that delivers the amplifiers output signal to a speaker
cabinet.
PAGE 6
NOTE: Failure to install the proper fuse
FREQ
FUSE
50/60 Hz
1 A
50/60 Hz
0.5 A
3
FUSE TYPE
AGC
AGC
ONLY!!!
4
Advertisement
