Table of Contents
Advertisement
DECK
ASSEMBLY
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle and deck assembly from
carton.
2. Attach handle assembly to base using
hardware kit (86219680 PRV NO. 47331)
(attached to handle in a plastic bag) items 1,
2, and 3.
NOTE: The spacers (items 1) are required for the
correct operation of the handle. The spacers are
positioned completely inside the pivot holes in the
casting, and are held in place by tightening the
bolts and washers (items 2 and 3) against the
spacer.
HANDLE
RECEPTACLE
4
5
LB1500 86037180 12/29/06
HANDLE INSTALLATION
HANDLE
ASSEMBLY
6
SEE NOTE
3. Remove bolt, nut and washers (items 4, 5 and
6) from lower block on handle assembly. Attach
links as shown. Tighten bolt and nut securely,
then back off 1/4 to 1/2 turn.
4. Check handle for movement up and down.
5. Plug motor cord into handle cord receptacle.
MOTOR
PLUG
PIVOT
HOLE
1
2
3
3-2
Advertisement
Table of Contents
