Magnavox MPD820 Owner's Manual page 35

MPD820_17.qxd 4/2/04
Connecting to additional equipment
Before you begin, make sure you have an RF modulator and extra RF coaxial cables.
These are not supplied with the player, but are available from Magnavox or most
consumer electronics retailers.
1 Connect the black end of the supplied cable to the player's AUDIO / VIDEO jack.
Connect the other yellow end to the VIDEO IN jack on the RF modulator. The VIDEO IN
jack on the RF modulator is usually yellow and might be labelled VIDEO, CVBS, COMPOSITE,
or BASEBAND.
2 Connect the red end of the same cable to one of the AUDIO IN jacks on the RF
modulator. Audio jacks on the RF modulator usually are red (right) and white (left). Match the
cable color to the jack color.
3 You probably already have an antenna or Cable TV signal connected to the ANTENNA IN jack
on your TV.
Disconnect it now from the TV. Reconnect the antenna or Cable TV signal to the
ANTENNA IN jack on your RF modulator.
IMPORTANT!
MAKE SURETV OUT / TFT ON IS AT THE TV OUT POSITION.
OTHERWISE,THERE WILL BE NO DISPLAY ON YOUR TV!
9:11 AM Page 35
Connecting to a TV Only
TV has only a single Antenna In or RF-In jack
35