Setting Time; Adjusting Display Brightness - RCA RP3753 User Manual

THE DIGITAL CD CLOCK RADIO
Protection against mains power failures:
1. Remove battery compartment door (located on
the back of the radio) by applying thumb pressure
to area indicated on battery door and then lift the
door out and off the cabinet.
2. Connect a 9-volt battery connector plug. (6LR61
or NEDA 1604A)
3. Insert battery in the compartment and replace
the compartment door.
NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be
used but memory holding time will be substantially reduced. Memory holding time for a
fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which
should take care of short, nuisance-type AC power failures. To preserve battery life, the unit
should remain plugged into an AC outlet. As the battery gets older, its voltage drops and
memory may be lost. Be sure to replace the battery periodically. Battery should be removed if
the unit will be stored for more than one month. Leaky battery can badly damage the clock
radio.

Setting time

TIME
W AKE 1
SET
SET
NOTE NOTE
NOTE NOTE NOTE:
1. Press and hold
2. The AM LED indicator will light to show AM time

Adjusting display brightness

You may slide
brightness.
1
RP3753 EN-US
SLEEP
>>
<<
W AKE 2
SNOOZE
SKIP
SET
SKIP
>>
<<
or
SKIP SKIP
on the left side of the unit to vary the LED display
OFF DIMMER ON
4
Battery compartment at the
backside of the unit
Press and hold
1
<<
Press
2
SKIP
to skip fast
TIME
SET
>>
or
SKIP
3/13/01, 4:11 PM