Test Tone / Channel Balance; Factory Setting - RCA RT2370 User Manual

Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator
for balancing the channels, As the signal "travels"
from channel to channel, adjust the level controls
until each channel plays at the same loudness level.
_3
Courtesy Dolby Laboratories
Level adjustment & surround channel level
expectation
Even though you adjust the surround channel to be
as loud as the others on the test signal, you'll find
that on actual program material the surround chan-
nel is usually much lower than the front. Don't be
tempted to readjust the surround level; program pro-
ducers use surround mostly for subtle atmospherics
and ambience, and only rarely for special effects. A
good surround mix doesn't call attention to itself; if
it did, it would soon become distracting.
)
Laboratories.
DD [ Dolby Digital Manufactured
DOLBY
under license from Dolby
Laboratories. "Dolby", "Pro
D _ G _ T A L Logic"
and thedouble-D
symbol are trademarks of
Dolby Laboratories. Copyright 1992-1997 Dolby
Laboratories, Inc. All Rights Reserved.
D _ o I TA L Manufactured under license from
Digital Theater Systems, Inc. US Pat. No.
5,451,942, 5,956,674, 5,974,380,
5,978,762 and other world-wide patents
issued and pending. "DTS" and "DTS Digital Surround"
are registered trademarks of Digital Theater Systems,
Inc. Copyright 1996, 2000 Digital Theater Systems, Inc.
All Rights Reserved.
SURROUND
All preset radio stations and surround sound setting
will be lost after factory setting is restored. You may
restore factory setting with the fo!lowing procedu[es:
1. Enter standby mode
2. Press SURR. MODE key when holding SOURCE UP.
3, AII preset stations wi!l reset to FM87.SMHz and aH
receiver settings restore to default settings as
described above.