Stihl BG-KM Instruction Manual page 7

grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
Small particles (e. g. dust) blown
through the blower tubes and nozzle can
cause a static charging of the blower
tubes. This is especially true in low
humidity and high dust conditions.
Starting
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your
KombiEngine and KombiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
With the engine running only at idle,
attach the power tool to the spring hook
of your harness (if you are wearing one).
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
See also the Safety Precautions on
Starting in the instruction manual of your
KombiEngine.
BG-KM
During Operation
Holding and Controlling the Power Tool
Always hold the unit firmly with both
hands on the handles while you are
working. Wrap your fingers and thumbs
around the handles.
Your right hand should grip the rear
handle. This also applies to left-handers.
Never attempt to operate your power
tool with one hand.
Watch out for small animals when using
the blower on open ground, in yards and
gardens.
WARNING
Do not overreach. Keep proper footing
and balance at all times. Special care
must be taken in slippery conditions (wet
ground, snow) and in difficult, overgrown
terrain. Watch for hidden obstacles such
as tree stumps, roots and ditches to
avoid stumbling. For better footing, clear
away fallen branches, scrub and
cuttings. Be extremely cautious when
working on slopes or uneven ground.
WARNING
To reduce the risk of injury from loss of
control, never work on a ladder, in a tree
or any other insecure support. Never
hold the machine above shoulder
height.
Working Conditions
To minimize blowing time, use a rake
and broom to loosen dirt particles before
you start blowing.
Save water by using a blower instead of
a water hose for lawn and garden work
wherever possible, e.g. for cleaning
yards and patios.
Recommended working technique to
minimize air pollution:
If conditions are very dusty, dampen
–
surfaces slightly before blowing.
Pull out the nozzle to full length so
–
that the airstream is at ground level.
Do not blow particles in the direction
–
of bystanders, in particular in the
direction of children, pets, open
windows or freshly washed
vehicles. Take special care in such
situations.
Remove the blow-swept debris in
–
rubbish bins – do not blow it onto the
neighbor's land.
Recommended working technique to
minimize noise:
Operate your power tool at
–
reasonable times only – not early in
the morning, late at night or during
midday rest periods when people
could be disturbed. Observe local
rest periods. Normal
English
5