The Echo Section - Ahuja AMX-912 Operation Manual

The Echo Section

l
The ECHO section provides ECHO, REVERB and CHORUS effects to all the Input channels. These Effects can be
obtained by different settings of Delay Control, Repeat Control and Level Control. The Echo Section can be switched
Off through a On/Off switch.
1. DELAY Control
For setting the time between ECHO repetitions.
2. REPEAT Control
This controls the number of repetitions of ECHO. The higher the
setting, the more repetitions.
3. LEVEL Control
For setting the ECHO level .
4. ECHO ON/OFF Switch
When this switch is in OFF position, AMX-912 operates as Mixer
only without Echo/Effects on all the inputs irrespective of the
settings of the Echo controls of individual channels.
5. PEAK LED
The Echo Controls & Fader Controls of each channel and Level
Control of Echo Section should be set at a level just below the
flickering level of this Peak LED. This LED is for optimizing the
Inputs and Echo levels. The settings of the Channel Faders &
Master Faders have no effect on this LED.
ECHO - Echo Effect is used to repeat the original
sound many times to give multiple voice effect and
is used for vocals. The Control settings for Echo
are as shown in the diag.
REVERB - Reverb is used for giving Hall Effect
to the original sound as repeated reflecting sound
raises overall level of the signal. This is also used
for public announcement in Stadia and Open Air
Performances. The Control settings for Reverb are
as shown in the diag.
CHORUS - Chorus Effect is used by a singer to
create an effect as if a Group is performing. The
control settings for Chorus are as shown in the
diag.
AMX-912
8
1
2
3
4
5