Power Supply Section - Ahuja AMX-912 Operation Manual

Power Supply Section

l
AC FUSE 1 Amps. 250V
1.
This protects the Mixer from damage in case of
excessive current flow. In case the fuse blows,
replace with another one of the same rating.
AC MAINS CORD
2.
This is for connecting to AC mains supply. The
Mixer is connected for 230V / 50Hz operation and
will perform satisfactorily even when the AC Mains
voltage drops to 200 V.
3. STANDBY 24V CAR BATTERY OPERATION
2 x 12V Car Batteries can be connected through
the DC Plug (supplied as an accessory) to the DC
Socket as shown in the diag. In case of power
failure, the Mixer continues to operate uninterrupted
through the standby 24V DC Supply. Make sure
the battery polarity is connected correctly.
4. EARTH TERMINAL
Before operating, the Mixer should be grounded
by connecting a wire from this Earth Terminal to a
water pipe or an electrical earth.
Use 2x12V car batteries exclusively for this
l
equipment and do not connect any other equip-
ment to these car batteries.
Connect car batteries only through pre wired
l
DC plug supplied With this equipment.
l Do not connect negative car. Car battery to
earth terminal.
l This equipment operates on floating 24V DC.
AMX-912
1
10
2 3 4