Additional motors and controls are used to
FOODS
DRY OUT
REFRIGERATOR
RUNS
TOO
provide the improved performance of this
(FRESH OR FROZEN)
FREQUENTLY
larger capacity refrigerator. Therefore, nor-
• Packages not wrapped or sealed properly
• Frequent running provides more stable
mal operating sounds may be more noticea-
ble than on the model it replaced.
• Crisper not tightly closed
temperatures
• Too many door openings
WATER
ON FLOOR
• Prolonged door openings
SIZZLING
SOUND
IN FREEZER
UNDER
CABINET
FRESH
FOOD COMPARTMENT
• Defrost pan missing or not positioned cor-
TOO WARM
• Normal sound caused by defrost water
rectly
dripping on defrost mechanism
• Refrigerator control set too warm
RED GLOW VISIBLE
IN FREEZER
MOISTURE
COLLECTS
ON
• Freezer control set at coldest position
• Reflection of defrost mechanism during
OUTSIDE
SURFACE
• Prolonged door openings
normal defrost cycle.
• Hot humid weather increases condensa-
FRESH
FOOD COMPARTMENT
tion. As humidity decreases, moisture will
ICE CUBES
EVAPORATE
disappear
TOO COLD
• Cold air moving over ice cubes causes
• Refrigerator control set too cold
cubes to shrink when not used regularly
CABINET
LIGHT
NOT WORKING
FREEZER COMPARTMENT
ICE CUBES STICKING
IN TRAY
• Bulb burned out
TOO WARM
• Trays may be coated with residue film
• No power at outlet
• Freezer control set too warm
from minerals in the water. Wipe trays
• Prolonged door openings
with vinegar-soaked cloth until clean. If
REFRIGERATOR
WON'T
RUN
residue is heavy, clean trays each time re-
frigerator is cleaned.
• Temperature control turned to OFF.
ODOR
IN CABINET
• Power cord not plugged in.
• No poweratelectricaloutlet.
IF YOU NEED
• Odor producing foods should be covered
• Interior needs cleaning
• .ouse fuse b.own
SERVICE
CABINET
VIBRATES
REFRIGERATOR
RUNS TOO LONG
Under normal conditions, due to larger
The model number, serial number, and bill
• Cabinet not level
• size and colder temperatures, modern re-
of material (BM) number of your model are
• Weak floor
frigerators run a greater percentage of the
listed on a serial plate. The serial plate is ]o-
time.
cared at the lower left side of the liner wall
WARM
AIR FROM
• Prolonged or frequent door openings,
next to the crisper drawer or the upper left
front corner of the liner. Refer to all of these
CABINET
BOTTOM
• Condenser needs cleaning,
numbers in any correspondence with your
• Normal air flow for condenser
• Poor air circulation around condenser,
dealer or distributor concerning your model.
102645-1
Need help?
Do you have a question about the CRD22AY-3A and is the answer not in the manual?