Samsung HL-T5055W Owner's Instructions Manual page 44

Ad'ustin the Screen Qualit
The purpose of the picture quality adjustment is to remove or reduce picture noise, if the noise is not removed by fine tuning
alone, then do the frequency adjustments to the utmost and fine tune again. After the noise has been reduced, re-adjust the
picture so that it is aligned on the center of the screen.
_- Change to the PC mode first.
1 Press the MENU button to display the menu.
Press the A or T button to select Setup, then press the ENTER button.
Press the A or T button to select PC, then press the ENTER button.
2 Press the ENTER button to select Image Lock.
Press the A or T button to select Coarse or Fine, then press the ENTER button.
Press the 4 or _ button to adjust the screen quality, then press the ENTER button.
Press the EXIT button to exit.
This feature may change the width of the image. If necessary, adjust the position to
center.
_the Screen Position
After connecting the TV to your PC, adjust the position of the screen if it is not well-
aligned.
_- Change to the PC mode first.
1 Press the MENU button to display the menu.
Press the A or T button to select Setup, then press the ENTER button.
Press the _, or T button to select PC, then press the ENTER button.
2 Press the A or T button to select Position, then press the ENTER button.
3 Press the A or T button to adjust the V-Position.
Press the _1or _ button to adjust the H-Position.
Press the ENTER button.
Press the EXIT button to exit.
initializin the Ima e Settin s
You can reset the previously adjusted settings to the factory defaults.
_-- Change to the PC mode first.
1 Press the MENU button to display the menu.
Press the A or T button to select Setup, then press the ENTER button.
Press the _, or T button to select PC, then press the ENTER button.
2 Press the A or V' button to select Image Reset, then press the ENTER button.
The message Image Reset is completed, appears on the screen.
Press the EXIT button to exit.
The previously adjusted settings will be reset to the factory defaults.
Continued...