Asus MAXIMUS VIII GENE User Manual page 114

Boot Logo Display [Auto]
[Auto]
[Full Screen]
[Disabled]
The following items appears only when you set the Boot Logo Display item to [Disabled].
Post Report [5 sec]
This item This item allows you to select a desired waiting time of the POST report from
0 to 10 seconds or until <ESC> is pressed.
The following items appears only when you set the Boot Logo Display item to [Full Screen]
or [Auto].
Post Delay Time [3 sec]
This item This item allows you to select a desired additional POST waiting time to
easily enter the BIOS Setup. You can only execute the POST delay time during normal
boot. The values range from 0 to 10 seconds.
This feature only works when set under normal boot.
Boot up NumLock State [Enabled]
[Enabled]
[Disabled]
Above 4G Decoding [Disabled]
This item enables or disables 64-bit capable devices to be decoded in above 4G address
space if your system supports 64-bit PCI Decoding.
Configuration options: [Enabled] [Disabled]
Wait For 'F1' If Error [Enabled]
Enable this item for the system to pause until the F1 key is pressed when any error occurs.
Configuration options: [Disabled] [Enabled]
Option ROM Messages [Enabled]
[Enabled]
[Disabled]
Interrupt 19 Capture [Disabled]
[Enabled]
[Disabled]
Setup Mode [Advanced Mode]
[Advanced Mode] This item allows you to go to Advanced Mode of the BIOS after POST.
[EZ Mode]
3-42
Auto adjustments for Windows requirements.
Maximize the boot logo size.
Hid the logo during POST.
Set the power-on state of the NumLock to [On].
Set the power-on state of the NumLock to [Off].
The Option ROM Messages will be shown during the POST.
Only the ASUS logo will be shown during the POST.
Execute the trap right away.
Execute the trap during legacy boot.
This item allows you to go to EZ Mode of the BIOS after POST.
Chapter 3: BIOS Setup