Magnavox MDV630R Owner's Manual page 27

6
Insert one end of the supplied power cable into the power outlet
4MAINS at the back of the DVD recorder and the other end
into the wall jack.
A message, '
remind you to set your TV to its Audio/Video In channel.
Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD recorder'.
USE THIS CONNECTION IF YOUR TV ONLY HAS A SINGLE ANTENNA IN JACK AND
DOES NOT HAVE ANY AUDIO/VIDEO JACKS.
Have the following cables ready:
an antenna cable (supplied), and a power cable (supplied).
1
Switch off your TV.
2
Remove the antenna or Cable TV signal from the antenna input
jack of the TV. Connect it to the ANTENNA jack at the back of
the DVD recorder.
3
Connect one end of the supplied antenna cable to the TV jack at
the back of the DVD recorder and connect the other end into
the antenna jack at the back of the TV.
4
Insert one end of the supplied power cable into the power outlet
4MAINS at the back of the DVD recorder and the other end
into the wall jack.
A message, '
remind you to set your TV to its Audio/Video In channel.
5
Switch on your TV and select the channel used for DVD/VCR
playback on your TV. Choose between channel 3 or 4. Use your
TV remote to set the TV to 3 or 4.
Connecting the DVD recorder
' will appear on the Recorder's display to
' will appear on the Recorder's display to