Setting The Universal Time Code (Utc) - HP f520g User Manual

2.6.3 Setting the Universal Time Code (UTC)

Depending on your location, you may need to change the current UTC
setting of the camcorder so that the correct date and time are updated
when a GPS signal is detected.
1. If recording is in progress, press the
2. Press the
3. Use the
Synchronization option and press the OK button. Ensure that the On
setting is selected and press the OK button again to view the UTC
setting.
4. Refer to the UTC Map below and use the
the desired setting and press the OK button to confirm the setting.
5. Press the
* Be sure to adjust for daylight saving time (DST) by adding +1 hour to the UTC
offset** These areas may observe half hour increments and daylight saving time
(DST)
button to open the OSD menu.
or buttons to navigate to the Satellite
button to exit the menu.
button to stop recording.
or button to select
17