2.5.3 Setting the Universal Time Code (UTC)
Depending on your location, you may need to change the current UTC setting of the
camcorder so that the correct date and time are updated when a GPS signal is
1. If recording is in progress, press the
2. Press the
3. Use the
Synchronization option and press the OK button. Ensure that the On
setting is selected and press the OK button again to view the UTC
4. Refer to the UTC Map below and use the
select the desired setting and press the OK button to confirm the
5. Press the
* Be sure to adjust for daylight saving time (DST) by adding +1 hour to the UTC
offset** These areas may observe half hour increments and daylight saving time
button to open the OSD menu.
buttons to navigate to the Satellite
button to exit the menu.
button to stop recording.