Panel - Magnavox 30MW5405/17 User Manual

B
1
ASIC
A combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69).Your connection is easy
because there is only one 75Ω (ohm)
antenna plug on the back of your TV, and
that's where the antenna goes.
1
If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the
TV.
If your antenna has a flat,
twin-lead wire (300 ohm), you
first need to attach the antenna
wires to the screws on a 300- to
75-ohm adapter.
2
Push the round end of the
adapter (or antenna) onto the 75Ω
(ohm) plug on the back of the TV.
If the round end of the antenna
wire is threaded, screw it down
finger tight.
B
ASIC
T he Cable TV input into your home
may be a single (75 ohm) cable. If so,
this connection is very simple. Follow the
steps below to connect your cable signal
to your new television.
1
Connect the open end of the
round Cable Company sup-
plied cable to the 75Ω input on
the TV. Screw it down finger tight.
A C
NTENNA ONNECTIONS
Antenna Connection
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
1
Twin Lead
Wire
Round Cable
75Ω
C TV C
ABLE ONNECTIONS
Direct Cable Connection
Cable signal
coming from
Cable Company
1
75Ω Round
Coaxial Cable
Monitor out AV1 in AV2 in
75‰
VIDEO
Y
L/Mono
S-VIDEO
AUDIO Pb
R Pr
COMPONENT VIDEO INPUT
300 to 75Ω
Back of TV
Adapter
75
Back of TV
ANT 75‰
Monitor out AV1 in AV2 in
VIDEO
Y
L/Mono
AUDIO Pb
S-VIDEO
R
Pr
COMPONENT VIDEO INPUT
Jack Panel
Back of TV
2