Tension Adjustment Of The Door Spring; Connection Of Drain Hoses - White Knight DW0945IA Instruction Manual

●

Tension adjustment of the door spring

The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust the door spring tension. Rotate
the adjusting screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Door spring tension is correct when
the door remains horizontal in the
fully opened position yet rises
to a close with the slight lift of a
finger.
●

Connection of drain hoses

Insert the drain h ose into a drain pipe with a minimum diameter of 4cm, or let it run into the s ink, making sure to
avoid bending or crimping it. Use the special plastic suppo rt that comes with the appliance . The top of the ho se
must be at a heig ht between 40 and 100cm. The free end of the hose must not be immersed in water to avoid the
back flow of it.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B, C
Close the drain hose hook to the counter
Note: The drain hose of this appliance must only be connecte d to a
"
discha rged into a fresh water
，
【 】
Figure5
Tension adjustment
of the door spring
Front
Drain pipe
"
drain.
relax
A
B
C
"
dirty water
Drain hose hook
Counter
φ 40mm
"
drain. Water must n ot be