SLIK SPRINT PRO II Operating Instructions page 2

How to use the center column
Loosen the Center column stopper while you
are holding the Pan head. Then loosen the
Center column locking nut. When you
determined your desired height, tighten the
both of the Center column stopper and the
Center column locking nut firmly before you
keep your hands away from the Pan Head.
Three position adjustable legs
To change the angle of each leg, close the leg
slightly. Then pull the 3-position leg angle
adjustment locks.
There is a choice of two other angle positions.
Lt.Caution
After choosing the desired leg angle, securely
push the Adjustment lock.
How to get low position shots
I
You can get lower height as shown the above.
Center column
base stopper
~
Extending/Folding of Tripod legs
Flip up the Leg lock lever to extend or shorten
any of the individual leg sections to the desired
length.
Press the leg lock lever flush against the leg to
lock.
Remove the Center column base stopper.
Then remove the Lower part of Center column.
Invertible Center column
It can be used for digital copy/or close-up
photography when a Center column is inserted
from the bottom.
Remove a Center column base stopper.
Then loosen Center column stopper and
Center column locking nut.
Put the Center column base stopper in to the
Upper part of Center column.
Lt,Caution
Center column base
stopper should
be attached.
Insert a Center column from the bottom.
Tighten a Center column stopper and Center
column locking nut firmly.
Please also make sure to attach a Center
column base stopper for fall prevention.
Care of the Tripod
• DO NOT apply any grease or oil to this product.
• Clean with a mild detergent and a soft cloth only.
• DO NOT use close to flame. Avoid extreme heat.
Slik Corporation reserves the right to make changes in design and/or improvements on the products without any obligation and ad vanced notice.
SliK CORPORATION
853 Kayama, Hidaka City,
Sa~ama
350-1231 Japan Phone 81-42-989-2141, Fax. 81-42-985-0210 ©2007
Printed in Thailand