Opening The 4496; 4496 Chassis Specifications - Lavry LavryBlue LE-4496 Operation Manual

LavryBlue 4496 Specifications
Opening the LavryBlue 4496
The modular design of the LavryBlue 4496 system allows for expansion and/or reconfiguration.
There are also some user configurable settings that are available inside the unit in the form of DIP switches
or jumpers. In either case, you will need to open the 4496.
Please note: the screws that go through the rack ears are longer and have a full conical head compared to
the top and bottom cover screws; which have a special "undercut" head. Please use care to replace the two
types of screws in the correct location when adding or moving modules (which requires removal of the
front panel).
First, BE SURE THAT YOU UNPLUG THE AC POWER CORD FROM THE BACK OF THE 4496
FRAME! DO NOT OPEN THE UNIT WITH THE POWER CORD CONNECTED.
Use a #2 Phillips screwdriver to remove the ten Phillips head recessed screws that hold the top cover in
place. Once these screws are removed, you can safely remove the top cover to reveal the printed circuit
boards.
- Please refer to the individual module's "Settings" section for the available switch settings and jumper
options.
-If an M•AD-824 module and M•SYNC are to be added to a 4496 that did not previously have them
installed, Lavry Engineering is required to perform the installation. There are a number of critical
calibrations that are part of this procedure. Field upgrades not performed by Lavry Engineering or an
authorized Lavry Dealer may void the warranty. Your dealer can provide assistance or you can contact
Lavry Tech Support: techsupport@lavryengineering.com
- If you need to add or change modules, please refer to the document under SUPPORT at
entitled "Upgrading your Lavry Blue."
www.lavryengineering.com
If you have any questions, please contact Tech Support: techsupport@lavryengineering,com
LavryBlue 4496 Chassis Specifications
The 4496 Chassis is a standard 1U 19"rack unit.
Input Voltage
"Universal" input accepts inputs of 90-264VAC, 47-63Hz, Internally fused 2.5A
Current Consumption @120VAC
Steady-state: Typically less than 0.5A (Varies with configuration/number of modules).
Steady-state Maximum: 1A
Dimensions
19" wide x 11.5"deep x 1.75" high
(Enclosure minus clearance for switches and connectors measures 10.5" deep)
Approximate Weight
~ 9 lbs (Varies with configuration/number of modules).
17