Table of Contents
Advertisement
LavryBlue 4496
( M•AD-824 Internal Settings- cont.)
DIP switch settings:
On – Master
Position 1:
On – XLR Pin 3 "+"
Position 2:
On – gentle ABC
Position 3:
Position 4:
future enhancements
● Please Note: "XLR Pin "+" refers to the "non-inverting" input. The opposite signal pin would be the
"inverting input" for balanced operation. For example Pin 2 "+" would mean Pin 3 was "-" or "inverting."
Jumpers Settings:
Balanced Audio Input Configuration:
● Please Note: In order to maintain good noise rejection qualities, Lavry Engineering recommends that
you use balanced inputs for unbalanced sources as well.
Four jumpers (J1, J2, J3 and J4) are located behind the analog input XLR connectors:
Please be sure to leave the jumpers set for balanced operation.
The settings are: J1 to "IN-P3," J2 to "IN-P2," J3 to "IN-P3," and J4 to "IN-P2"
Soft Saturation: Jumper- J6 enables the lowering of the threshold for the analog soft saturation feature,
and is labeled to denote the THRESHOLD. The default mode is a connection between the center pin and
the front pin- HIGH position. A more aggressive saturation curve occurs when lowering the saturation
threshold by connecting the center pin to the rear pin- LOW position). Default setting- High threshold
saturation starts at –3dBFS, J6 jumper set to LOW threshold saturation starts at –6dBFS.
Off - Slave
Off- XLR Pin 2 "+"
Off – aggressive ABC
Operation
9
Hide quick links:
Advertisement
Table of Contents
