Advertisement
Quick Links
Advertisement
Related Manuals for Thrane&Thrane Sailor RT2048 VHF
Summary of Contents for Thrane&Thrane Sailor RT2048 VHF
- Page 1 USER MANUAL SAILOR RT2048 VHF...
- Page 2 INTRODUCTION The SAILOR RT2048 VHF radiotelephone has been designed to comply with the increasing demands of a highly technological product, which means high quality, small size, etc. The SAILOR RT2048 has furthermore been designed to fi t into the SAILOR Compact 2000 module programme.
- Page 3 NOTE: PRIVATE CHANNELS There is standard provision for the 1. The distress call should be programming of up to 10 private repeated from time-to-time channels. However, it is possible until an answer is heard. to increase the total to 40 private 2.
- Page 4 CONTROLS SCAN DELETE Deletes a channel from the scanning table. Indication of ON/OFF/VOL turn-style knob operation. Selects the scan time from 1 to 99 seconds. The time chosen SCAN TIME will be used to listen on one of the secondary channels receiving a signal.
- Page 5 READ-OUT • CHANNEL READ-OUT All international maritime channels are shown by the two digits, when the channel has been keyed in. Selection of a standard private channel will be indicated with a P-. • • • TRANSMITTING REDUCED POWER US-CHANNELS Whenever the handset switch is In harbour areas, or in the close In the USA a number of the inter-...
-
Page 6: Operation
OPERATION How to Return to How to Return to The VHF radiotelephone is operated by means of two turn-style knobs 25W Output Power International Channels and a push-button keyboard. This combination ensures a high continuous resolution on squelch and AF-level, and an easy selection of channels etc Press: Press: in all situations. -
Page 7: Selective Calling
SELECTIVE CALLING DUAL WATCH OPERATION (If built-in) In addition to the selected channel, which is shown on the display, the VHF When a selective call is received from a coast station, the read-out station will listen on channel 16 for 0.1 second every 1.2 second. will alternatively show CA, and the actual selected channel and the acoustic alarm will sound for 10 seconds. -
Page 8: Scanning Operation
SCANNING OPERATION (If scanning is enabled) How to Return to the How to Delete a Channel from The VHF radiotelephone is provided with a flexible scanning facility. Last Channel with Signal the Scanning Programme The scanning programme is fully user programmable, and can include all the international channels and the ten private channels PO -P 9. - Page 9 How to Programme/Change the "Scan Time" To set the "Scan Time" to 10 seconds press: SCAN SCAN TIME TIME SHIFT SHIFT Note! After "SHIFT" "Scan Time" has been keyed in. The maximum time between the following entries must be 2.5 seconds, or the input sequence will be ignored.
- Page 10 CHANNEL APPLICATION AND FREQUENCY TABLE FREQUENCIES SIMPLEX DUPLEX FREQUENCIES FREQUENCIES SIMPLEX DUPLEX FREQUENCIES • • • • Tx: 156.025 MHz Tx: 156.050 MHz Tx: 156.050 MHz Tx: 156.025 MHz • • Rx: 160.650 MHz • • Rx: 160.625 MHz Rx: 160.625 MHz Rx: 160.650 MHz Tx: 156.100 MHz Tx: 156.075 MHz...
- Page 11 QUICK SELECT CHART Distress and Call Channel Channel Selection U.S. US-mode (Channel Required in the USA) SHIFT Reduced Power SHIFT D.W. Dual Watch SHIFT SCAN Start Scanning SHIFT SCAN Add a Channel to Scanning Programme SHIFT SCAN Delete a Channel from Scanning Programme DELETE SHIFT SCAN...
- Page 12 B2048GB Issue: C/0548 Thrane & Thrane A/S info@thrane.com www.thrane.com • •...
Need help?
Do you have a question about the Sailor RT2048 VHF and is the answer not in the manual?
Questions and answers