Chevrolet 2014 Camaro Owner's Manual page 350

10-94 Vehicle Care
It is not recommended that the air
extractor on the ZL1, SS and 1LE
Performance Package be waxed, as
it will change the gloss level of the
surface. In addition, care must be
used when waxing around the air
extractor. If a small amount of wax
is applied to the extractor it can
create an irregular appearance in
the surface of the panel. If wax,
debris, or other materials create
stains on the air extractor, see your
dealer for the recommended
cleaner.
The air extractor has vent screens
in the openings. Keep leaves or
other debris out of the vent screens.
Caution
Pushing on the vent screens
could damage them. Do not push
on the screens when clearing.
There is a water deflector on the
underside of the air extractor. Do
not remove it.
Convertible Top Care
Frequently hand wash convertible
tops with mild car wash soap. Never
use a stiff brush, steam, bleach,
or aggressive cleaners.
If necessary, a soft brush can be
used to remove dirt. When finished
cleaning, thoroughly rinse the fabric.
Avoid automatic car washes with
overhead brushes or very high
pressure sprays as they can cause
damage and leaking.
Only lower the top when it is
completely dry and avoid leaving
the top lowered for extended
periods of time to prevent excessive
interior weathering.
Avoid leaving large amounts of
snow on the top for extended
periods of time as damage may also
occur.
Cleaning Exterior Lamps/
Lenses and Emblems
Use only lukewarm or cold water, a
soft cloth, and a car washing soap
to clean exterior lamps, lenses and
emblems. Follow instructions under
"Washing the Vehicle" previously in
this section.
Lamp covers are made of plastic,
and some have a UV protective
coating.
Use only lukewarm water, a soft
cloth, and mild car washing soap to
clean exterior lamps and lenses. Do
not clean or wipe them while they
are dry.
Do not use any of the following on
lamp covers:
Abrasive or caustic agents.
Washer fluids and other cleaning
agents in higher concentrations
than suggested by the
manufacturer.
Solvents, alcohols, fuels,
or other harsh cleaners.
Ice scrapers or other hard items.
Aftermarket appearance caps or
covers while the lamps are
illuminated, due to excessive
heat generated.