Barco G2100 Series Replacement Procedure page 8

LCD Panel Replacement for G2100 series
- Unplug the flat cable by opening the cable slot on the
connector and by pulling out the flat cable.
Connector cable removal/insertion
: connector cables are
6‡‡r ‡v‚ 
in the respective connectors
Q…r††Ã‡‚ȁy‚px
Connector
- Turn out both retaining screws (screwdriver 8 mm).
- Slide out the total assembly and lay down carefully on a
table.
- Slide the new assembly in the 2100 frame so that the
centering pins fit into the centering holes.
- Secure this position by turning in both retaining screws.
- Re-install the flat cable connection and secure by
closing the connector slot.
Service Instructions
y‚pxrq
p‚  rp‡‚…Ã
phiyr
Q…r††Ã‡‚Ãy‚px
Date: 22/09/98 R808293K - R809419K
R808293K
R809419K
8