Advertisement
LCD Panel Replacement for G2100 series
Œa. The front panel needs to be removed and this is
achieved by firstly opening the front control panel and
gaining access to the two large locking screws on either
side of the control panel. Unlock by turning one half turn
counter clockwise. The front panel can now be released
from its mountings by tilting forwards slightly, then lifting
upwards and outwards (the front control panel should
remain in the open position at all times).
Tools Required
Phillips screw driver (PH0)
Flat Top Screw Driver
Wrench, Spanner (N
- 7,8,10)
o
Œb. Once the front panel has been removed the internal
projector and loud speakers are visible. The right loud
speaker is of significance since, if it is chosen to remove
the projector from the front direction, then this speaker
must also be removed first. This is done by removing all
four of its attachment nuts on the top and right pillars of the
lower cabinet structure.
The rightside panel must next be removed. The rightside
panel is removed by loosening its attaching screws and
then pivoting outwards the front edge of this panel a little,
now pull the front edge out to release it.
a. Once the right panel has been removed the projector
rightside bracket locking screw is visible. A mental
note of this screws location should be made as it will be
required to be undone in stage .
Service Instructions
FRONT
PANEL
FRONT
PANEL LOCKING
SCREWS
PROJECTOR
RIGHTSIDE
PANEL FIXING
SCREWS
PROJECTOR
RIGHTSIDE BRACKET
LOCKING SCREW
Date: 22/09/98 R808293K - R809419K
R808293K
R809419K
Œ
FRONT
CONTROL
PANEL
Œ
a
Œ
b
RIGHT
SPEAKER
î
í
a
3
Advertisement
