TABLE OF CONTENTS SAFETY RULES �����������������������������������������������������������������������������������������������������������������������������������������������������������������������������3 FIRE PROTECTION ����������������������������������������������������������������������������������������������������������������������������������������������������������������3 SAFETY EQUIPMENT ������������������������������������������������������������������������������������������������������������������������������������������������������������3 LOW VOLTAGE REMOTE CONTROL ����������������������������������������������������������������������������������������������������������������������������������3 INSPECTION OF POWER UNIT �����������������������������������������������������������������������������������������������������������������������������������������3 PLANNING ����������������������������������������������������������������������������������������������������������������������������������������������������������������������������������4 LIST OF TOOLS REQUIRED �������������������������������������������������������������������������������������������������������������������������������������������������4 SELECT THE LOCATION FOR THE POWER UNIT �������������������������������������������������������������������������������������������������������������4 CHOOSE THE HOSE LENGTH ��������������������������������������������������������������������������������������������������������������������������������������������4 LOCATION OF VACUUM INLETS ��������������������������������������������������������������������������������������������������������������������������������������4...
1. SAFETY RULES INSPECTION OF POWER UNIT Piping installation for a central vacuum system is not complicated. All that is required is to have a few hand tools and to read the instructions carefully. However, it is essential to do The Power Unit and all connections should be inspected before starting and at regular the installation carefully and safely.
2. PLANNING CHOOSE THE HOSE LENGTH Installing the piping for a central vacuum system does not require specialized tools and can be done by anyone. However, it is important to take time to plan the installation carefully. Be sure to check the positioning of inlets several times, in relation to furniture, the length of the hose and the components that will be inside the wall.
Use the following method to check the location of vacuum inlets: he garage If structurally possible, install a vacuum inlet close to the door to increase the reach of the hose outside during the summer. PIPING Before starting installation, plan the trajectory of the piping system to be the most effective. To do this: •...
WARNING! ackeTed low volTage wiring Extremely flammable. Keep away from open flame and sparks. Use only in a well ventilated area. KEEP OUT OF REACH OF CHILDREN. FIRST AID! » CONTAINS METHYLETHYLKETONE (MEK) AND Jacketed wiring is recommended since it offers mechanical protection to the low voltage wiring. Wires may be pulled CYCLOHEXANONE.
TUY-28 TUY-44 This connection combines two 45° elbows to make two branches at To terminate a line of pipe, use only a cap. 90° from the main line. Double 45° IMPORTANT! Other means of capping a pipe may damage the Power Unit when starting or TUY-22 The Short Tee is only used to place an inlet directly in the middle create an obstruction if the cap enters the...
IMPORTANT! or new consTrucTion Install piping before partitions are enclosed. The mounting plate can The front face of the mounting plate must not be above the finished wall surface! be attached directly adjacent to the studs using its installation The front face of the mounting plate must be a few millimeters inside the finished support.