Introduction; Opening The Front Cover; Installing A Memory Card; Installing The Desiccant Pack - Garmin VIRB X Owner's Manual

Introduction

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
It is your responsibility to use the device in a safe manner.
Garmin will not be responsible for any property damage, injuries
®
or deaths resulting from any use of this device in any activities.

Opening the Front Cover

You must open the front cover to install the battery, memory
card, and anti-fog desiccant pack.
1
Grip the top and bottom of the latch
latch.
2
Open the front cover.

Installing a Memory Card

You must install a microSD
For optimal performance, use a class 10 or better memory card.
1
Open the front cover.
2
Insert the memory card
contacts facing the lens.
3
Press in the card until it clicks.
4
Close and latch the front cover.

Installing the Desiccant Pack

Do not eat desiccant packs. Desiccant packs contain silica,
which may cause irritation in your digestive system. Desiccant
packs are harmful if swallowed by an infant or pet due to
choking hazard.
You should install an anti-fog desiccant pack for optimal
performance and fog resistance.
1
Open the front cover.
2
Insert the desiccant pack into the desiccant tray
Introduction
WARNING
and pull to open the
™ memory card to use your device.
into the memory card slot with the
WARNING
3
Insert the desiccant tray into the desiccant slot.
4
Close and latch the front cover.
The indicator dot on the desiccant pack turns pink when the
desiccant pack becomes saturated. Heat the desiccant pack at
85°C (185°F) for 60 minutes to dry the desiccant pack for reuse.

Installing the Battery

This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
1
Open the front cover.
2
Locate the metal contacts on the end of the lithium-ion
battery.
3
Insert the battery
4
Press the battery into place.
5
Close and latch the front cover.

Charging the Battery

To prevent corrosion, thoroughly clean and dry the contacts and
the surrounding area on the side of the device before charging
or connecting to a computer. Refer to the cleaning instructions in
the appendix.
Do not attempt to use the device to charge a battery that was
not provided by Garmin. Attempting to charge a battery that was
not provided by Garmin can damage the device and void the
warranty.
1
Plug the USB cable into a USB port on your computer.
2
Align the charger posts with the contacts on the side of the
device, and press the charger
.
WARNING
into the compartment, contacts first.
NOTICE
until it clicks.
1