Advertisement
Washing Instructions
1. Sort the laundry into loads according to material
type and/or colours. Note: there are 5 basic load
types:
A. White cottons and linens.
B. Colourfast cottons and linens.
C. White synthetics and cotton blends.
D. Nylons and coloured synthetics.
E. Delicates.
2. Place the Ezywash on a solid flat surface with
easy access to a sink or tub.
3. Add the required amount of water and detergent
according to the washing chart on the back
page of this manual - for best results and easier
rinsing, make sure to add the detergent and
water before adding the clothes.
4. Add the laundry.
5. Locate the pressure lid on the top of the Ezywash
and turn clockwise about a one eighth turn - until
it will not move any further.
6. Tighten the pressure knob on the top of the lid in
a clockwise direction until fully tight.
7. Using the handle, turn the Ezywash approximately
one turn per second for the recommended time
as per the chart on the back page of this manual.
8. After washing, unscrew the pressure lid by turning
the knob slowly in a anti-clockwise direction to
release the pressure, then remove lid. Do not
remove the knob completely.
9. To drain, insert the water release valve at the
bottom right of the drum. To do so, push slightly in
and turn the valve a quarter turn clockwise, until it
clicks into position. Make sure the end of the water
release valve is over a sink or basin.
Rinsing
1. After draining the dirty water & removing the water
release valve, leave the laundry in the Ezywash and
fill with clean cold water. Replace the pressure lid,
tighten and turn the machine for about 30 seconds.
Drain and wring dry. Repeat if necessary.
Advertisement
