Philips WP3893 User Manual page 13

When you replace the filter, the pure water
dispenser performs the Pure Flush function
automatically. In this case, 10 litres of water flow
out of the appliance (see chapter 'Cleaning and
maintenance', section 'Replacement').
Warning:
B
Do not drink the water that comes out of the
appliance during the PureFlush procedure.
Switch on the pure water dispenser.
1
Wait until the dispense button d flashes
(ready to dispense - manual mode).
Place a container with a capacity of at least
2
10 litres under the pure water dispenser.
Press and hold the dispense button d for 4
3
seconds.
• The PureFlush procedure starts, during
which 10 litres of water come out of the
appliance.
• The dispense button lights up green to
indicate that Pure Flush is in progress.
All other indicators are off.
Note:
D
If you want to cancel the flushing procedure
while it is in progress, press the power-on
button y to switch off the pure water dispenser.
6.1.2 Audio on/off
The pure water dispenser is equipped with an
audible signal that reminds you that dispensing
is in progress. The default setting for this audible
signal is 'off '. If desired, you can switch on the
audible signal.
Press the power-on button y.
1
Make sure the appliance is in manual mode
2
and wait until the dispense button d flashes.
Press and hold the LITRES button.
3
When you press and hold the lITRES button
for more than  seconds, you hear the audible
signal.
To switch the audible signal off, press and hold
the lITRES button again for  seconds.
Note:
D
The audio setting reverts to the default setting
(off) when the pure water dispenser is switched
on the next time.
13