Advertisement
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of the power unit.
Important - UK only
The wires in the cord are coloured
as follows:
Blue = Neutral
Brown = Live.
The appliance must be protected by
a 3A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Remove all the packaging .
2 Wash the parts: see 'cleaning'.
3 Twenty four hours in advance,
place the bowl into a freezer.
4 Prepare the ice cream or sorbet mix
(see recipe ideas). Allow the mix to
cool in the refrigerator.
key
On/off switch
Power unit
Lid
Spindle
Paddle
Bowl
to use your ice-cream
maker
1 Slide the power unit onto the lid until
it locks in place, the clips on the
underside will click into place.
2 Place the spindle into the power
unit, then attach the paddle.
3 Remove the bowl from the freezer.
4 Lower the assembled unit onto the
bowl and turn the power unit/lid
clockwise to lock into position.
5 Switch on.
THE MACHINE MUST BE
SWITCHED ON EFORE ADDING
THE ICE CREAM OR SORBET
RECIPE TO PREVENT THE MIX
FROM IMMEDIATELY FREEZING ON
THE INSIDE OF THE BOWL.
6 Use the chute and pour the ice-
cream or sorbet mix into the bowl.
When pouring mixture into the bowl,
always stop at least 2.5cm from the
top, as the mixture will increase in
volume during freezing.
7 Allow the mixture to churn until
frozen or the desired consistency is
reached, this can take up to 30 to
40 minutes, but most recipes will be
ready in less time.
import nt
Do not stop and start the machine
during the freezing process, as the
mixture may freeze in contact with
the bowl and prevent movement of
the paddle.
To avoid overheating the motor, the
direction of rotation will change if the
mixture becomes too thick. If the
direction of rotation continues to
change, stop the machine as the
mixture is ready.
In the unlikely event of the motor
overheating, a safety cut out will
operate causing the motor to stop.
If this happens, switch off, unplug
the machine and allow the power
unit to cool.
8 Switch off, remove the power unit/lid
by turning anti-clockwise. The ice
cream is ready to serve.
The ice cream produced should be a
soft spoonable type. This can be
transferred to a separate container
4
Advertisement
