If the freezing solution appears to
be leaking from the bowl,
Unplug the machine before fitting
discontinue use. The freezing
or removing parts or cleaning.
solution used is non toxic.
Keep children away from the
Do not place the machine on hot
machine. And never let the cord
surfaces such as stoves, hotplates
hang down where a child could
or near open gas flames.
before plugging in
Never use a damaged machine.
Make sure your electricity supply is
Get it checked or repaired : see
the same as the one on the
underside of the power unit.
Never put the power unit in water
important - UK only
or let the cord or plug get wet -
The wires in the cord are coloured
you could get an electric shock.
Never use an unauthorised
Blue = Neutral, Brown = Live.
The machine complies with
Avoid contact with moving parts.
European Economic Community
Keep hands, hair, clothing ,
spatulas and other utensils away
before using for the first
during operation to reduce the risk
of injury to persons and/or
1 Remove all the packaging .
damage to the machine.
2 Wash the parts: see 'cleaning'.
Do not use outdoors.
Never leave the machine on
3 Twenty four hours in advance,
place the bowl into a freezer.
4 Prepare the ice cream or sorbet
Don't let infirm people use the
machine without supervision.
mix (see recipe ideas). Allow the
Don't let children play with this
mix to cool in the refrigerator.
Only use the machine for its
intended domestic use.
Always make sure everything is
thoroughly clean before making ice
cream or sorbet.
Never freeze ice cream that has
fully or partially defrosted.
Any ice cream or sorbet etc
containing raw ingredients should
to use your ice-cream
be consumed within one week.
Ice cream tastes best when fresh,
so do not make too far in advance.
1 Slide the power unit onto the lid
Ice cream or sorbet etc that
until it locks in place, the clips on
contains raw egg should not be
the underside will click into place.
given to young children, pregnant
2 Place the spindle into the power
women or the elderly.
unit, then attach the paddle.
To prevent freezer burn, always
3 Remove the bowl from the freezer.
ensure that hands are protected
4 Lower the assembled unit onto the
when handling the bowl, especially
bowl and turn the power unit/lid
when first removed from the
clockwise to lock into position.
5 Switch on.
THE MACHINE MUST BE
Do not use metal utensils to
SWITCHED ON BEFORE
remove mix from the bowl.
ADDING THE ICE CREAM OR
Do not remove the bowl from
SORBET RECIPE TO PREVENT
the freezer until ready to make ice
THE MIX FROM IMMEDIATELY
FREEZING ON THE INSIDE OF
We suggest that you keep the
6 Use the chute and pour the ice-
bowl in the freezer so that it is
cream or sorbet mix into the bowl.
ready for use. Place in a plastic
When pouring mixture into the
bag before freezing. Freeze the
bowl, always stop at least 2.5cm
bowl in the upright position.
from the top, as the mixture will
Always make sure the bowl is
increase in volume during freezing.
thoroughly dry before placing in
7 Allow the mixture to churn until
frozen or the desired consistency
Do not puncture or heat the bowl.
is reached, this can take up to 30
The bowl should be placed in a
to 40 minutes, but most recipes
freezer that is operating at a
will be ready in less time.
temperature of -18°C or below for
24 hours before use.
Do not stop and start the machine
For best results always refrigerate
during the freezing process, as the
the ingredients before making ice
mixture may freeze in contact with
the bowl and prevent movement of
The addition of alcohol to recipes
inhibits the freezing process.
To avoid overheating the motor,
the direction of rotation will change
if the mixture becomes too thick. If
the direction of rotation continues
Always switch off , unplug and
to change, stop the machine as
dismantle before cleaning.
the mixture is ready.
Never put the power unit in water
In the unlikely event of the motor
or let the cord or plug get wet.
overheating, a safety cut out will
Don't wash parts in the
operate causing the motor to stop.
If this happens, switch off, unplug
the machine and allow the power
Allow the bowl to reach room
unit to cool.
temperature before attempting to
8 Switch off, remove the power
unit/lid by turning anti-clockwise.
1 Wash the inside of the bowl, then
The ice cream is ready to serve.
dry thoroughly. Do not immerse in
The ice cream produced should be
a soft spoonable type. This can be
transferred to a separate container
Remove then separate.
for storage in the freezer or if you
1 Wash then dry thoroughly.
wish to firm the ice cream before
Remove lid from power unit:
1 With the lid upside down, pinch
one pair of clips together to
release one side of the lid
repeat with the other pair of clips.