Loudspeaker Cables - Audiolab M-PWR User Instructions

4: Connections-2
In the UK a fused 13 Amps mains plug should be fitted with a fuse link rated
to 13 Amps which conforms to BS1362. In other countries a value between 10
Amps and 15 Amps should be used at either the wall socket or at the mains
distribution board. If you are in any doubt you should consult a qualified
electrical engineer.
Use of correct connectors and cables
You should ensure that any cables which are used with Audiolab M-PWR Stereo
Amplifier are properly terminated and that the cable is appropriate to the task.
This is particularly important with loudspeaker cables and connections. If you
are in any doubt you should consult your dealer.

Loudspeaker Cables

Loudspeaker cables should be carefully prepared. The following sketches
show the preparation of a speaker cable for use with Audiolab M-PWR Stereo
Amplifier and loudspeakers. When stripping the insulation, be careful not to
cut into the wire. Make sure that you collect together all the strands of wire as
stray wires may cause shorting which could result in damage or cause a fire.
When estimating the length, provide sufficient loudspeaker cable to enable
easy access and tidy securing. Some cables are quite heavy and you should
be careful to place your cables so that they do not cause undue strain on the
binding posts of the amplifier or loudspeaker.
Note: Ensure that cables used with Audiolab M-PWR Stereo Amplifier are
appropriate to the task and correctly terminated.
Audiolab M-PWR english manual.in6 6
Page 5
2013-3-11 12:29:04