Providing Mains Power; Vhf Wire Antenna; Setting The Appliance Up; Preparing The Station For Ipod/Iphone - Silvercrest SKRI 2000 A1 Operation And Safety Notes

GB
Disinstallation

Setting the appliance up

Preparing the station for iPod/iPhone

Providing mains power

VHF wire antenna

48
♦ Place the appliance aslant, with the front recesses in the top face of the
appliance, in the mounting plate
upwards against the mounting plate
into place.
♦ Check to ensure that the appliance is securely seated.
♦ Pull the appliance forwards and remove the appliance downwards.
♦ Unscrew the screws on the mounting plate
plate .
20
As an alternative you can stand the appliance on a level surface. In order to
avoid the ventilation slots and speaker
covered, the two foot-pads
♦ Reach into the recess on the side of the respective foot-pad and pull the
hinged foot out as far as it will go.
♦ Select a suitable installation location for the appliance (see also the section
Set-up location requirements p. 45).
You can connect your iPod/iPhone to the appliance. For this you must fold the
station down and install the locking clip
29
♦ Fold the station
29
♦ Remove the locking clip
♦ On each side of the station
from the front onto the station
recesses.
♦ Connect the connector plug of the power adapter
on the rear panel of the appliance.
♦ Insert the power adapter
♦ Unwind the wire antenna
Setting up and connecting
. Press the rear part of the appliance
20
until the appliance audibly locks
20
on the bottom of the appliance being
23
on the appliance must be hinged outwards:
21
:
22
all the way down.
from the side of the appliance.
22
there is a recess. Slide the locking clip
29
so that the retaining lugs engage in the
29
into a mains power socket.
15
completely for VHF reception.
27
and remove the mounting
20
into the DC socket
15
SKRI 2000 A1
22
25