Operations; Counting; Adding; Batching - AccuBANKER AB6000 User Manual

Part One

3.0 Operations

3.1 Counting

Turn the unit ON. Adjust the counting guides for proper feeding. the unit comes programmed
from the factory to start counting in Automatic mode. If this function is present, the unit will
count all the bills placed in the hopper. The counting mode can be switched to Manual by
changing the counting mode as explained in page 19, Auto/Man sub-setting

3.2 Adding

Addition can be performed in two different ways:
a- Units: Do not enter any specific bill denomination. Place bills on the hopper. Once counted,
press the Select button to add them Total (total units) count shown at the
bottom of the Main Task Screen
b- Amount: enter the desired bill denomination. Place bills on the hopper. Once counted, press
the Select button to add them to the Value (total amount) count shown at the
bottom of the Main Task Screen. The denomination of the bills can be changed at any time.
This will not reset the current addition operation.

3.3 Batching

On the Main Task Screen look for the Bat (batch) function.
Enter the desired batching quantity using the buttons on the control panel:
To clear the current batching number press the
NOTE: The screen will enter Screen saver mode after 60 seconds.
Press any key to light the screen again.
Operations
button.
C
1 2 3
4 5 6 C
100
7 8 9 0
21