Advertisement
Quick Links
Advertisement
Related Manuals for SI 7 SERIES
Summary of Contents for SI 7 SERIES
- Page 1 7 SERIES MOTORIZED EXTERNAL...
- Page 2 7 Series Motorized External Instructions Warnings 1) Do not change the upper limit. Screen damage and injury may result from improper upper limit setting. 2) The required Operating Temperature Range of this product is 65F - 85F (15C - 29C).
-
Page 3: Installation Parts List
7 Series Motorized External Instructions Installation Parts List Mounting Brackets Mounting Bracket Wing End Cap Screws Bracket Lock Power Cord Screws & Driver Bit & Allen Wrench Nuts Wall Switch Low Voltage Wall Switch / IR Remote & Receiving Eye... - Page 4 7 Series Motorized External Instructions Installing the brackets 1. Determine the mounting position of the brackets on the wall. Provide at least 1/2’’ clearance between top of bracket and ceiling to allow for fascia clearance. Make sure the brackets are securely mounted to structural lumber 2’’ to 12’’ from each end of the case.
- Page 5 7 Series Motorized External Instructions Hanging the cassette—two installers and two ladders are required to safely lift the cas- sette into position. 3. Center the cassette under the brackets with the cas- sette opening on the floor and the curved section facing away from the wall.
- Page 6 7 Series Motorized External Instructions Connecting the screen assembly to upper cassette 9. a) Position the black screen packing tube on the floor centered directly below the case. The “Left” label will be on the viewers left hand side, while the Front label should be visible on viewer’s right side.
- Page 7 7 Series Motorized External Instructions Setting the viewing height and installing the wing end caps 11. a) Raise the screen to the desired viewing height. Start by turning on the projector and projecting the image at the desired height on the wall.
- Page 8 7 Series Motorized External Instructions Locking the final height of screen IMPORTANT NOTE: The following steps will permanently lock the final viewing height in place. Do not proceed with these steps until you’re certain of the final viewing height, and that the screen is set to that position as described in Step 11.
- Page 9 7 Series Motorized External Instructions Removing protective tube from screen 15. a) Slide rubber bands off tube on each end, then cut 15. b) Remove Velcro band from middle of tube and discard. with scissors and discard. 15. d) Remove rubber bands off tube on each end, then 15.
- Page 10 7 Series Motorized External Instructions Setting the lower screen limit 16. a) Continue unrolling the screen with the Down button while carefully watching the bottom tube from behind the screen. Release the button when the arrow on the tube is at 12:00—denoted by a red arrow on the tube (as shown in the images below).
-
Page 11: Operating The Screen
7 Series Motorized External Instructions Operating screen and confirming limits 18. Operate the screen as desired using the control method you’ve selected for your screen. Please Note: The stop button has been disabled. The screen will stop at the programmed limits. However, If you do need to stop the screen before it is going to reach it’s programmed limit, then press the up and down buttons on the wall switch at... - Page 12 7 Series Motorized External Instructions LIMITED ONE YEAR WARRANTY ON SCREEN INNOVATIONS BLACK DIAMOND MOTORIZED PRODUCTS Screen Innovations warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Screen Innovations’...
Need help?
Do you have a question about the 7 SERIES and is the answer not in the manual?
Questions and answers