Subscribe to Our Youtube Channel
Related Manuals for SI SOLO
Summary of Contents for SI SOLO
- Page 1 Screen Innovations Connect Instructions 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com...
-
Page 2: Table Of Contents
Step 3: Pair Your Connect ........Pg 7 Thank you for purchasing an SI product. If you Method A - Using Solo Remote ... Pg 8 have any questions or need any assistance with Method B - Without Solo Remote ..Pg 9 your Connect product, we would love to help you. -
Page 3: Initial Information
INITIAL INFORMATION Unpack the Connect from the shipping box. Parts in the Box: Connect Instructions SI Infrared Connect remote Instructions Connect Plug-in 12V power supply Initial Information Pg 1 Initial Information Pg 2... -
Page 4: More About Connect
Connect operates independently of the Solo Remote. The unit should be mounted with the base down and at least 1” of air gap around the Connect to provide for 3”... -
Page 5: Installation
INSTALLATION Step 1 Plug the 12V power supply into the wall socket. Step 2 Plug the barrel connector on the power supply into Step 1 the power port. The status indicator LED will light up and is viewable through the case on the side opposite the ports. -
Page 6: Step 3: Pair Your Connect
Step 3 - Pair Your Connect Pairing Method A - Using the Solo Remote If the Connect was shipped with your Solo, it will be With a large paperclip, press the button on the back paired with the screen. If purchased seperately, the of the remote until the screen jogs once. -
Page 7: Step 4: Control
Caution: Holding the button longer than one jog, may erase the motor settings and unpair every remote. All remotes will then have to be re-paired and all limits reset using the Solo remote. Installation / Step 3 / Pairing Method B... - Page 8 3.5mm mono audio jack. The remote IR eye can now from the SI IR Remote or using these hex codes: be placed in a location accessible to the IR remote (Available on the website too.) while the Connect is kept hidden.
-
Page 9: Method B - 12Vdc Trigger
Control Method B: 12VDC Trigger Control Method C: Dry Contact A DC trigger voltage will cause the Connect to send This method of control is for use with momentary RF commands to the screen to operate it. This wiring contact switches, such as a push button switch, or method is usually used to allow the projector to relays, commonly found in control systems. -
Page 10: Subsequent Installation
SUBSEQUENT INSTALLATION To send the screen UP, momentarily connect the wires to pins 4 and 6. Likewise, the Connect power LED will go dark and the screen will roll up to the If Connect needs to be moved, simply unplug the upper limit. - Page 11 Tech Support: 512.832.6939 Tech Support: 512.832.6939 CONNECT TROUBLESHOOTING Symptom Possible Cause Solution Symptom Possible Cause Solution SI IR Connect is not paired Pair Connect with Remote with screen the remote or No Power Power supply not Plug in power is non-...
- Page 12 Tech Support: 512.832.6939 Tech Support: 512.832.6939 Symptom Possible Cause Solution Symptom Possible Cause Solution Plug-In IR Screen is not Charge for 10 min. 12VDC Triggering device is Repair or replace Eye is non- or plug in if a Trigger not sending the the device, or use charged or plugged responsive...
Need help?
Do you have a question about the SOLO and is the answer not in the manual?
Questions and answers