Advertisement
CAUTION: To reduce the risk of electric shock and/or damage to the camera, do not
disassemble this camera or open the casing. There are no user-serviceable parts inside and
breaking the camera's weather seal may allow humid air to enter the camera which can cause a
foggy or washed-out image. Always use a power supply which meets the specified voltage and
meets or exceeds the specified current. Voltage drop over a cable's length should always be
taken into consideration.
UNPACKING AND HANDLING
Each unit is shipped fully assembled and factory tested. There is no need to open the housing
of the camera and doing so will void the warranty.
Ensure that all accessories are removed from the box before discarding the packing material.
Take care to ensure that the label with the camera's serial number is not removed or damaged.
The serial number is needed to determine whether or not a camera is under warranty.
MECHANICAL INSPECTION
Inspect the camera for signs of shipping damage. Ensure that the equipment is clean and that
no connections are damaged or loose. If the camera appears to be damaged or defective, call
your distributor or SecurityTronix at 1 (800) 688-9282 for assistance.
SPECIAL ATTENTION
The installer must comply with electrical safety standards - There must be sufficient
space between the camera's power supply and video line and any high voltage
equipment or cables.
To help ensure the camera's life and proper operation do not point the camera towards
the sun or strong light.
Do not install the camera in an environment where the temperature is above 113 F. Do
not install the camera near a magnetic field or a high-power motor. Do not mount the
camera near a radiator or heater.
Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe
gently with a mild detergent. Never use strong or abrasive detergents.
A minimum I2VDC 700mA power supply must be used. AC power using a 24VAC power
supply @ 400mA can be used. Using an incorrect power supply will damage the camera.
Only qualified installers are allowed to install, configure and test the camera.
The IR LED angle and lens viewing range are adjusted at the factory, Any change to the
cameras lens will affect image quality.
The camera is a low voltage product, if installed outdoors proper safety and lightning
grounding are required.
INSTALLATION AND OPERATION
Advertisement
